Taiwan's Shangyin HIWIN Technology Co., Ltd. created its own brand HIWIN with "Hi-Tech Winner". It is the world's first ball screw manufacturer with ISO9001, ISO14001 and OHSAS18001 certifications. It is also the most complete professional manufacturer of linear transmission products in the world. By. The Group's main products include: ultra-high precision ball screws, precision linear slides, precision linear modules, Single Axis Robot, precision linear bearings, linear actuators, linear motors, planar motors and drives, magnetic ruler measurement systems, Intelligent slide rails, linear motor drive XY platform, linear motor gantry system, etc.
The advantages of the silver linear guide are as follows:
(1) High positioning accuracy
When the linear slide is used as the linear guide, since the friction of the linear slide is rolling friction, not only the friction coefficient is reduced to 1/50 of the sliding guide, but also the difference between the dynamic friction and the static friction is small. Therefore, when the bed is running, there is no slippage, and the positioning accuracy of μm can be achieved.
(2) Less wear and can maintain accuracy for a long time
The traditional sliding guide will inevitably cause poor platform motion accuracy due to the reverse flow of the oil film, and the lubrication will not be sufficient due to the movement, resulting in the wear of the running track contact surface, which seriously affects the accuracy. The wear of the rolling guide is very small, so the machine can maintain accuracy for a long time.
(3) Suitable for high-speed motion and greatly reduce the driving horsepower required for the machine
Since the friction of the linear slide is very small, the bed can be operated with less power, especially when the bed works in a regular round-trip operation, and the power loss of the machine can be significantly reduced. And because of the small heat generated by its friction, it can be applied to high speed operation.
(4) It can withstand loads in the up, down, left and right directions at the same time
Due to the special beam structure design of the linear slide rail, it can bear the load in the up, down, left and right directions at the same time. Unlike the sliding guide, the lateral load that can be withstood in the direction of the parallel contact surface is light, which is easy to cause the running precision of the machine. bad.
(5) Easy to assemble and interchangeable
As long as the assembly surface of the slide rails on the bed table is milled or ground, and the slide rails and the sliders are respectively fixed to the machine table with a specific torque according to the recommended steps, the high precision during machining can be reproduced. Conventional sliding guides require shoveling of the running track, which is both time consuming and time consuming, and once the machine is not accurate, it must be shoveled again. Linear slides are interchangeable and can be replaced with sliders or slides or even linear slide sets, allowing the machine to regain high-precision guidance.
(6) Simple lubrication structure
If the sliding guide is insufficiently lubricated, it will cause the contact surface metal to directly rub the bed, and the sliding guide is not easy to be lubricated. It is necessary to drill the oil in the proper position of the bed. The linear slide rail has been installed on the slider, and can be directly greased by the oil gun. It can also be replaced with a special oil pipe joint to connect the oil supply pipe to lubricate the automatic oil supply machine.
