Operation steps of fiber laser cutting machine:
1. Determine the materials to be processed, place the sheet metal material flat on the processing machine, and then determine the stability of the material placement to avoid jitter during the cutting process, which will cause the cutting accuracy to fall short.
2.Operate the console, input the product cutting pattern, thickness of the cutting material and other parameters, then adjust the cutting head to the appropriate focus position, and then reflect and adjust the nozzle center.
3. Start the regulator and chiller, and set the water temperature and pressure of the chiller.
4. Turn on the laser and then turn on the machine.
Although the above four points are brief, in the actual operation process, it takes a lot of time to practice and get familiar with the details of each operation. It is inevitable that there will be some failures and problems when operating the fiber laser cutting machine. Let me summarize and share them below.
1. No response after booting
◆ Whether the power fuse tube is burnt out: Replace the fuse tube.
◆ Whether the power input is normal: Check the power input and make it normal.
◆ Whether the main power switch is damaged: Replace the main power switch.
2. No laser output or weak laser
◆ Whether the light path is shifted: Carefully adjust the light path.
◆ Whether the focus distance of the equipment changes: readjust the focus.
◆ Whether the laser tube is damaged or aging: Replace the laser tube.
◆ Whether the laser power is on: Check the laser power supply circuit to make it normal.
◆ Whether the laser power is damaged: Replace the laser power.
3. There is an error in the processing size or an incorrect operation
◆ Whether the signal line is normal: Replace the signal line.
◆ The power supply is unstable or has interference signals: install a voltage stabilizer or eliminate interference signals.
Whether the processing parameters are set correctly (such as layout): reset the corresponding parameters.
◆ Whether the processing program writing is normal: Check the processing program and modify it until it is normal.
Post time: Feb-10-2020
