Fiber laser cutting machine inevitably has some minor problems during use, especially the phenomenon of abnormal reset, which often makes us feel very headache. If we have a reset abnormality when using it, what should we do?
1. The X-axis and Y-axis movement direction of the laser cutting machine is opposite, and the side end is hit. This phenomenon should check whether the motherboard parameters are wrong. It is necessary to stop and check whether the parameter settings of the motherboard are problematic.
2, the laser cutting machine control panel display is normal, X-axis and Y-axis do not move, you can try to pull the sensor terminal of the motherboard to see if the machine has action, this situation should consider replacing the sensor.
3. The beam is reset normally. The X-axis of the laser cutting machine is not reset, and the motor wire may be broken or the motor shaft may be broken. This phenomenon is to replace the motor wire or small motor.
4. The direction is correct when resetting, but when it reaches the apex, the X axis or Y axis can't stop (check the motherboard parameters first). If it is correct, check the motherboard or sensor for this phenomenon and replace it.
Post time: Aug-30-2019
